| 1. | Maximum torque control for field weakening operation of asynchronous motor applied in electric vehicle
电动汽车用异步电机弱磁运行的最大转矩控制 |
| 2. | In practice , outputs of motors are constrained by max torque , so do outputs of controller
在实际应用中，电机输出受到最大转矩限制，则控制器的输出也是受最大转矩限制的。 |
| 3. | They develop peak torque capabilities with high slide acceleration and low intertia for optimized system response
他们产生最大转矩的能力比功能产生迅速滑动加速和最优化系统响应。 |
| 4. | Simulation results showed that this control strategy can decrease the stator current anti improve the efficiency of the system
仿真结果表明永磁同步电动机直接转矩控制系统最大转矩电流比控制可以降低定子电流，减小损耗，从而提高系统效率。 |
| 5. | In this paper , the maximum torque per ample ( mtpa ) control in permanent magnet synchronous motor ( pmsm ) direct torque control ( dtc ) driving system was studied
摘要在永磁同步电动机直接转矩控制和最大转矩电流比控制理论基础上，研究了永磁同步电动机直接转矩控制驱动系统最大转矩电流比控制的实现。 |
| 6. | Based on artificial neutral network control theory , a mimo neutral network pid speed regulator realizing the maximum torque with minimum current is conformed for a pmsm drive system
本论文在人工神经网络控制理论的基础上，针对永磁同步电动机矢量控制系统，构造实现最大转矩电流控制的mimo神经网络pid速度控制器。 |
| 7. | By adjusting the fuel rectifying screw and then increasing the fuel quantity per cycle , the loss of the maximum power of e30 engine ca n ' t exceed 10 % of the maximum power of diesel , and the loss of the maximum torque can be controlled within 2 percent
通过旋出油量校正螺钉，增大燃料供给量，可以使e30混合燃料发动机的最大功率损失控制在10以内，最大转矩损失控制在2以内。 |
| 8. | In real robotic manipulators there are many constraints such as max torque of motor , rotation angle of joint , difference in length of the working time span . these constraints are not in accordance with the assumption of iterative learning algorithm and so bring difficulties to the application of it
但是，机械手在现实工作中存在很多的限制，比如：电机最大转矩的限制、关节转角的限制、工作时间区间不等长等，这些不满足迭代学习算法标准前提假设的现实情况，给迭代学习算法的应用带来了一定的困难。 |
| 9. | Based on the torque - speed characteristic curve of induction motors , analyses were done on changes in slip with an variation in frequency when an induction motor drives different kinds of loads , including those with constant torque , constant - maximum torque , variable torque ( except fans and pumps ) and constant power , as well as fans and pumps , the formulas to calculate the slip and the speed under different frequencies and loads were presented
摘要以异步电动机机械特性曲线为基础，分析了变频调速异步电动机在拖动恒转矩负载、恒最大转矩负载、变转矩（非风机和泵类）负载、恒功率负载以及风机和泵类负载时，转差率随频率变化的规律。 |
