| 1. | Earth - moving machinery - seat index point
司机座椅标定点 |
| 2. | Earth - moving - seat index point
司机座椅标定点 |
| 3. | Determining seat index point
测定座位标定点 |
| 4. | Earth - moving machinery , and tractors and machinery for agriculture and forestry - seat index point
农业和林业用土方机械拖拉机和机械设备.座位标定点 |
| 5. | This paper presents an improved method on how to utilize the asm efficiently under fewer landmarks conditions
本文研究在了只有少量关键标定点情况下，如何有效的进行主动形状建模的问题。 |
| 6. | In order to improve calibration precision without increasing computation complexity , tsai ' s two - stage calibration technique with calibration points in multiple planes is refined
为了进一步提高标定精度,对利用多平面标定点的tsai的两步法进行了改进。 |
| 7. | Through changing the gravity center of face contour dynamically and combining with the traditional asm , the improved method overcomes the problem of modeling asm under fewer landmarks
通过充分利用面部轮廓标定点的信息，提出了一种将而部轮廓质心动态变化和传统主动形状模型相结合的策略，解决了在少量标定点条件下主动形状建模所遇到的问题。 |
| 8. | Leaving the rated load , especially with low load and free running operation , ihe efficiency of turbocharger and ratio boost pressure decrease , leading to the shortage of air in cylinders and worsening of combustion , and the economic , power and exhaust performances deteriorate
当偏离标定点，尤其在低负荷和空转工况工作时，增压器效率降低，增压压力明显下降，导致气缸供气不足，缸内燃烧不良，柴油机的经济性能、动力性能和排放性能将严重恶化。 |
| 9. | The results derived from comparison experiments indicate that various performances of the diesel engine adopting the best project is better than those of the previous intake manifold . especially at the rating , the volumetric efficiency and power increases by about 5 % , exhaust temperature decreases by 50 , 4 . 3g / kw . h fuel consumption is reduced , o . srb smoke emission is cut down
试验表明：该方案与原机进气系统方案相比，其各项性能指标均有不同程度的改进：在标定点的充量系数和功率提高了将近5 ，排温下降了50 [ ] ，燃油消耗率减少了4 . 3 [ g kw |
| 10. | According to the engineering criterion of the cooling system , the function and the characteristic of the cooling system are checked at the case of rating and torque , thus two schemes are compared to select the better one , and also the boundary condition for further computational fluid dynamics ( cfd ) analysis is provided
按照冷却系统工程规范，分标定点与转矩点两个工况来检查冷却系统的功能和特性，以比较两种结构方案的优劣，也为下一步进行计算流体动力学分析( cfd )提供边界条件。 |
