| 1. | The fractue experimental research of maraging 350 torsional rods 大型连杆分模面混晶及粗晶魏氏组织 |
| 2. | Associative taper plane reference point 相关的拔模面参考点 |
| 3. | Contour smooth technique in cae - oriented die - face design for automotive panel 的汽车覆盖件模面设计中零件边界光顺技术 |
| 4. | Method for generating additional surface in die face design of automotive panel 汽车覆盖件模面设计中补充曲面的生成方法 |
| 5. | The integral operator is introduced such that the control system achieves a zero steady state error 滑模面中积分算子的引入确保了闭环系统零稳态误差的性能要求。 |
| 6. | Kohler illumination was used in proximity lithography , and a fly ' s eye lens was adopted to form multi - point source in order to uniform the light intensity on the mask plane 摘要接近式光刻中一般采用柯勒照明系统,并采用蝇眼透镜形成多点光源均匀掩模面的光场分布。 |
| 7. | By applying reaching law approach , the selected control law ensures that all trajectories starting off the manifold reach it in finite time and have low chattering in the sliding motion 引入趋近律方法设计控制律,有效的削弱了抖振并能保证系统在有限的时间内到达滑模面。 |
| 8. | Variable boundary layer solution is applied to eliminate chattering on the sliding surface and pi speed identifier of mras is used to replace traditional speed sensor to monitor the speed 应用可变边界层法削弱滑模面上的抖振,用模型参考自适应速度辨识器取代传统速度传感器监测电机速度。 |
| 9. | Ill the time - varying sliding surface is obtained by rotating and / or shifting the initial sliding mode surface , and the existence of sliding mode with the time - varying sliding surface is proved 通过旋转和平移初始滑模面得到一个时变的滑模面,并证明了在此滑模面条件下滑动模态的存在性。 |
| 10. | According to the requirement of die designing , the die parting face and the gutter is designed . by boolean calculation , the blocker , finisher , cut - off die and stripper are generated 根据锻模设计要求,设计了分模面、毛边槽,通过布尔运算,生成了预锻模、终锻模、切边模实体和卸料板。 |