Chinese translation for "滤波器电路"
|
- filter circuit
Related Translations:
组合滤波器: combining filtercomposite filters 延迟滤波器: delay filterfilter with time delay 相关滤波器: correlation filter
- Example Sentences:
| 1. | At last , the integrated active filters that accord with this thesis ' s request is developed
最终制造出达到设计预期要求的高性能有源带通滤波器电路。 | | 2. | Current - mode continuous - time filter is current - mode circuit , so it has characteristics of current - mode circuit
本文还对版图基本理论以及滤波器电路的版图的实现进行了研究。 | | 3. | The simulative circuits of active network elemellts and analog signal operation based on ota are induced systematically
论文研究跨导运算放大器及其滤波器电路的原理和设计。 | | 4. | Based on the theoretical studies , a band - pass filter circuit is optimized in order to decrease current density and increase the electromigration lifetime
在理论研究基础之上，借助于计算机辅助设计，针对一个带通滤波器电路进行了电路优化，以提高其电迁移寿命。 | | 5. | Abstract the paper gives a circuit of second band active filter ? made of secondary current transmitter , it not only is of the function ? of the voltage filter , but also the current one
摘要提出一种使用第二代电流传输器构成的二阶带通有源滤波器电路,它既可实现电压滤波功能,也可实现电流滤波功能 | | 6. | The paper studies the theoretics and synthesis of current feedback operational amplifier ( also called transirapedance operational amplifier , for short cfoa ) and cfoa - c filter circuit , introduces the present state of the research of analogy integrated circuit
本文研究电流反馈运算放大器(又称跨阻运算放大器，简称cfoa )及其滤波器电路的原理和设计。 | | 7. | Finally the module is accomplished successfully after installation and debugging . it mainly consists of the minimum system of dsp , a / d conversion circuit , cpld control logic , watchdog circuit , op amplifier and filter circuit
该模块主要由数字信号处理器最小系统、模数转换电路、复杂可编程逻辑器件控制逻辑、看门狗电路、运算放大器电路和模拟滤波器电路构成。 | | 8. | In this part the signal from the infrared sensor was amplified by common collector amplifier , and the demodulator was built by filter . in which the signal got demodulated . because we just need the frequency of the signal , filter may achieved
通过信号通路,传感器生成的调幅波信号转变为与脉搏频率相同的方波。先由运算放大器接共集电极电路完成信号放大,通过滤波得到脉搏信号的频率,从而用滤波器电路完成了解调功能。 | | 9. | Become a kind of new electronics circuit - current - mode circuit . it is replacing the traditional design method of the voltage - mode in the high frequency high - speed signal processing realm 。 this thesis mainly discussed the modified second - generation current conveyors based on the current - mode kinds of new cuicuit components , they are stronger modified standard current - mode parts in fuctions on this foundation . mainly including the modified differential difference current conveyor ( mddccii ) 、 the fully balanced second generation current conveyor ( fbccii ) 、 ( full balances ) four - terminal floating nullor ( fbftfn ) and the current differencing buffered amplifier ( cdba ) , they are all function very strong standard current - mode parts , they all can provide some circuit functions of better than general operation amplifier , because they have the voltage importation and the current importation , therefore use it since can carry out the voltage - mode signal processing circuit expediently , can also carry out the current - mode signal processing circuit expediently , and have to increase the benefit bandwidth to accumulate more widely than the voltage - mode , but have their advantages more according to the current - mode filter of the modified current conveyor , because it constitutes in brief , the filter wave function is stronger and they are better than in general use operation amplifier of many advantages , be easy to composing for example 、 high speed 、 frequency bandwidth 、 the power supply voltage requests low 、 consume small , the impedance is different from etc . advantages , otherwise they have biggish dynamic range , and flexible circuit synthesize , so they are the best active parts
从第二代电流传输器ccii入手,重点研究了以下几种改进型的第二代电流传输器:改进的差动差分电流传输器mddccii 、全平衡第二代电流传输器fbccii 、多输出四端浮地零器ftfn 、全平衡四端浮地零器fbftfn 、电流差分缓冲放大器cdba的电路结构及其模型。然后在此基础上系统地研究了基于这几种改进型的第二代电流传输器的滤波器的设计方法,主要方法和结果如下:利用mddccii设计了差分式连续时间电流模式低通、带通滤波器;电流模式跳耦结构考尔低通滤波器;利用fbccii设计了带通二阶节滤波器及电流模式双二阶通用滤波器;设计了基于多输出端ftfn的电流模式二阶通用滤波器电路;通过数字化开关选择的基于fbftfn的电流模式通用滤波器;设计了基于最少个数电流缓冲放大器(两个cdba )的多功能通用电流模式滤波器及其在非理想因素情况下分析。设计滤波器的主要方法是采用级联设计、运算模拟(信号流图法)和反馈设计(跳耦法) 。 | | 10. | In this section , the main content is about the transducer and the low - pass filter . the simulation program of wave filter circuit and the stability of wave filter and analogue signal pspice analysis are integrated in chief . these are constituted as a circulatory feedback mode , so that it speeds the process of establishing electric circuit parameters
尤其在低通有源滤波器的分析与设计这部分内容中，将滤波器电路的程序仿真、滤波器稳定性分析和pspice分析设计有机的结合起来，组成了一个循环反馈的分析模式，加快了电路参数的确定过程，缩短了产品的研发周期。 |
- Similar Words：
- "滤波器的鉴别力" Chinese translation, "滤波器的临界频率" Chinese translation, "滤波器的滤波能力" Chinese translation, "滤波器的时间常数" Chinese translation, "滤波器的泄漏透射比" Chinese translation, "滤波器电容器" Chinese translation, "滤波器扼流圈" Chinese translation, "滤波器分辨率" Chinese translation, "滤波器分隔" Chinese translation, "滤波器分析" Chinese translation
|
|
|
