Chinese translation for "灌浆压力"
|
- grouting pressure
Related Translations:
灌浆阀: grout valvegroutvalve 灌浆设备: cementing outfitgrouting devicegrouting equipment 灌浆孔: grout holegroutig holeinjection boring 灌浆套筒: grout sleevegroutsleeve 灌浆管: [建筑] grout pipe◇灌浆管机 grouter; 灌浆管帷幕 [工业] grout curtain
- Example Sentences:
| 1. | Allowable grouting pressure
地基处理容许灌浆压力 | | 2. | It is suggested that the pressure should be controlled in a certain limits to avoid unduly fracture to the soil
为避免过分压裂土层，在压浆过程中应控制灌浆压力。 | | 3. | The theoretical calculation and simulating tests show that the grouting liquid with the stabilizing agent mac has good groutability . it has higher spreading radius than that used bentonite as stabilizing agent under the same grouting pressure . 4
理论计算和灌浆模拟实验表明聚合物稳定剂水泥浆液可灌性好，在相同一的灌浆压力下，聚合物稳定剂水泥浆扩散半径明显大于膨润土稳定剂水泥浆。 | | 4. | Gin is the abbreviation for grouting intensity number . it is showed by the product of the final grouting pressure p ( unit : mpa ) on the grouting section and the grouting volume v ( unit : l / m ) on every one meter of the grouting section , which means the energy consumed on every one meter of grouting section . according to gin method , if during the grouting construction , same energy is consumed on every grouting section , i . e . gin keeps to be a constant , an approximately uniform impervious curtain can be obtained
Gin ( groutingintensitynumber )即灌浆强度值，它用灌浆孔段上最终的灌浆压力p ( mpa )和单位灌浆段长度浆液灌注量v ( l / m )的乘积表示，其含义为单位灌浆段上消耗的能量， gin法灌浆认为在灌浆施工中，保持各灌浆孔段上消耗一致的能量，即保持gin为常数，便可形成一道大致均匀的防渗帷幕。 | | 5. | According to the computation process of the fem and assumption , associating of the fem mesh that have separated and the grouting stress diffusion equation , the integral stiffness matrix and the load matrix can be formatted , then the displacement of the nodal point can be got after solving the simultaneous linear equations . and then the grouting parameter can be computed and analyzed
然后，依据有限元法的计算步骤和所作的假设，结合已经离散化了的网格、灌浆压力扩散衰减公式，形成整体刚度矩阵、荷载矩阵，经求解后得到结点的位移，并依此计算分析灌浆参数。 | | 6. | Lastly , two conditions were simulated and computed by using the fem program : two pieces of joint and one piece of joint which have different depth , different grouting stress , different pressure on the ground surface , etc . and then some results were obtained about the relation of the grouting press , the lifting of the ground surface and the cosumptionof the injection grout
最后，依据所编的程序对不同埋深、不同灌浆压力、不同压重等的单条节理裂隙的灌浆情况和两条节理裂隙的灌浆情况进行了模拟计算，得出了一些结论：灌浆压力、地表抬动和注浆量之间的关系。 | | 7. | The distance of the single - row curtain grout hole is between 1 . 4 to 1 . 8 meter , and 2 . 0 meter is suitable for the double - row curtain ; the grouting pressure generally is 1 . 0 to 1 . 5 mpa at the first three grout compartment , then grouting pressure of under the fourth control in 4 to 5 mpa ; for mast grout compartments , a water - cement ratio of 2 or 1 may used in the first grouting
钻孔密度也由原来的0 . slm / mz降至o . 64n扩mz ，节约工程投资447 . 35万元。 6 、单排帷幕的孔距在1 . 4一1 . 8m之间，双排帷幕的孔距以zm为宜;灌浆压力在地表以下前三段一般为1一1 . smpa ，第四段以下按4一smpa控制;对大部分孔段而言，开灌水灰比可定为2或1 。 | | 8. | 3 . the carstic formation is permeable layer and has quite good placeability , its relations of the water permeabitity and placeability have three types as follows : high unit - absorption rate with big grout consumption , the grouting is necessary ; low unit - absorption rate with little grout consumption , the grouting is no need ; low unit - absorption rate with big grout consumption , grouting is no need combining with control the grouting pressure and grout consumption . 4
岩体透水率与可灌性之间一般存在以下三种组合关系：高单位吸水率与大吃浆量的组合，灌浆是必需的；低单位吸水率与小吃浆量的组合，没有必要灌浆；低单位吸水率与大吃浆量的组合，应进行灌浆处理，但应适当控制灌浆压力和耗浆量。 |
- Similar Words：
- "灌浆围堰" Chinese translation, "灌浆系统" Chinese translation, "灌浆险证" Chinese translation, "灌浆效果" Chinese translation, "灌浆修补" Chinese translation, "灌浆岩石锚栓" Chinese translation, "灌浆岩石铆栓" Chinese translation, "灌浆用砂" Chinese translation, "灌浆预应力钢筋混凝土构件中的钢筋" Chinese translation, "灌浆造模法" Chinese translation
|
|
|
