| 1. | Locate the 3 - pin cmos password reset jumper on the system board
找到3引脚cmos密码重置跳投对系统板。 |
| 2. | Design and implementation of high - speed sdh transmitting system between different boards based on hdlc protocol
传输系统板间通信的设计与实现 |
| 3. | The whole tasks are including hardware design and software programming of the mscis interface system
整个研究工作从mscis接口系统板卡的硬件设计和软件编程两方面展开。 |
| 4. | Located at the exit of mrt chunghsiao - fuhsing station of panchiao / nankang line . the most convenient and fast shopping ground
位于捷运系统板南线忠孝复兴站4出口，出门购物快速方便！ |
| 5. | On intel - based eisa computers , if the hardware problem is in an adapter , the adapter slot number on the system board is displayed
对于基于inteleisa的计算机，如果硬件问题发生在适配器上，就会显示出系统板上的适配器插槽号码。 |
| 6. | This microcontroller systems embedded tcp / ip protocol is proposed in the paper has many advantages , such as lower cost , fewer component , smaller area of hardware , higher transport speed , and easier to use
本文设计的这种嵌入tcp ip协议的单片机系统板，具有成本低、硬件少、占用面积小、传输速度快、使用方便等优点。 |
| 7. | Specially , after the application of mb89f538 microcontroller , design and finish the development board and main system board . it analyzes the hardware and software realization of each part in this system
进一步介绍了单片机mb89f538的功能特点,设计制作单片机开发板和主系统板,采用模块化设计思想,分析了基于超声波测距的新型倒车雷达系统各部分的硬件及软件实现。 |
| 8. | Experiment indicates that the converter realizes the data transfers function between the rs232 serial communicating port and the ethernet rj - 45 connector . it means that the converter realizes the protocol conversion . the software of the protocol converter is developed by the client / server mode
实验表明本论文设计实现的协议转换器系统板实现了rs232串行通讯口与以太网rj - 45接口的数据双向传输功能，也就是说可以完成rs232串行通讯口协议与tcp ip协议的协议转换功能。 |
| 9. | Second based on high performance dsp - tms320c32 , design and realizing the hardware of the system - mainboard of data collecting and processing . it includes 1 ) external memory system 2 ) the interface of accelerators and fog 3 ) dart 4 ) boot loader 5 ) decoding and reset system 6 ) interface of jtag
为了实现系统功能，系统板在硬件上主要具备了以下结构： 1 )外部扩展存储器系统； 2 )陀螺反加速度计接口电路； 3 )通用异步串行口电器( uart ) ； 4 )程序引导装载电路； 5 )译码反复位电路； 6 ) jtag接口。 |
