Chinese translation for "组织均匀"
|
- well-closed formation
Related Translations:
均匀冷却: even coolinghomogeneous coolinguniform cooling 很均匀: wellproportionedwellpropotioned
- Example Sentences:
| 1. | After moulding , the surface of dough becomes smooth and the texture of dough looks even
整型后表面光滑,组织均匀 | | 2. | Uniform micro - structure , compacted grain : melting iron is solidified by heavy spin force at right temperature , which effectively avoid the failures like blowhole , slag enclosure , pinholes and etc
组织均匀，晶粒致密：温度精确的合金溶液在上百倍的离心重力作用下凝固成型，得到致密的组织；并有效克服了气孔、夹渣、疏松等缺陷。 | | 3. | Under the same experimental conditions , the reaction is more thorough and the durative time of the reaction is also longer when the quantity ratio of cuo to the other oxides is 3 : 1 than when it is 2 : 1
在相同的实验工艺条件下， cuo粉末与其它氧化物粉末的质量比为3 ： 1时，原位反应比2 ： 1时彻底，持续时间较长，所制备铝基复合材料微观组织均匀细小。 | | 4. | Powder metallurgy ( pm ) superalloys has the advantage of homogeneous organization , superfine grain , high yield strength and high elevated temperature fatigue strength , so it becomes the first choice material for the new turbine disks
而粉末高温合金材料具有组织均匀、晶粒细小、屈服强度高、高温疲劳性能好等优点，已成为新型涡轮盘的首选材料。 | | 5. | Based on these parameters , the performs with the outer diameter 1200mm , the inner diameter 600mm and thickness 100mm were prepared . composition and microstructure homogeneity combined with fine primary silicon grain and uniform distribution of sic reinforced particles of 15 % were achieved
并在此工艺参数下,制备出了不同硅含量的铝基复合材料环坯,其尺寸为1200 600 100mm ,沉积坯的组织均匀、初晶硅细小,增强相sic颗粒的分布均匀,体积分数约为15 % 。 | | 6. | Secondly , the effect of transverse deforming on the property of the wedge pressing was studied . the results showed that : the wedge pressing stock with the transverse deforming amount of 10 % acquired the best performance . the highest density got the biggest rate of slope while with the amount of 30 % the curve was more some special structure and performance as following : the large porosities was crushed into small or linear ones with the high - direction deformation amount of 20 % ; as the increasing of the high - direction deforming , the particles got a further deforming , the porosities got a further crushing , the small porosities were mergered by the large ones and the former then disappeared ; when the amound reached 60 % , the quantity of the porosities would obviously decrease which made the materials compact , the microstructure more uniform and the density and hardness curves more horizontal , the relative desity could reach 99 . 7 % , the tensile strength b of the as - compacted samples reached 408mpa with the yield strength s teached 289mpa and the elongation percentage reached 13 . 6 % . in addition , the microstructure of the wedge pressing stock under the pressing temperectureof 450 was uniform , the porosities and the boundries of the grains basically disappeared and the conjunction between particles was great
采用双向楔形压制,大尺寸喷射沉积5a06铝合金楔压坯的组织和性能变化具有如下特点:当高向变形量为20 %时,大的孔洞变形破碎为小的孔洞,或呈线状孔;随着高向变形量的增加,颗粒进一步变形,孔洞进一步破碎,大孔“吞并”小孔,小孔塌陷并逐步消失;当高向变形量达到60 %时,孔洞量大为减少,材料基本致密,组织趋于均匀,楔压坯料的密度、硬度变化曲线接近水平线,坯料的相对密度达99 . 7 % ,抗拉强度_ b = 408mpa ,屈服强度_ ( 0 . 2 ) = 289mpa ,延伸率= 13 . 6 % ;对比其它的压制温度,在450楔形压制的坯料组织均匀,孔洞及颗粒边界基本消失,颗粒之间冶金结合良好。 | | 7. | The welding line microstructure of ticp / fe in situ composites gained by different welding technologies and welding methods was different . however the microstructure was diffused on the welding line and there were no welding defects , the welding quality was better . the tic reinforced particles on the welding line still kept the same shape as that of the casting microstructure
原位tic _ p fe复合材料采用不同焊接工艺和焊接方法所得的焊缝组织有所差别，但焊缝处的组织均匀，没有裂纹等焊接缺陷产生，可焊性较好；焊缝处的tic增强颗粒仍保持铸态组织中tic增强颗粒的形态。 |
- Similar Words：
- "组织矩阵结构" Chinese translation, "组织巨吞噬细胞" Chinese translation, "组织决策模型" Chinese translation, "组织均衡论" Chinese translation, "组织均浆" Chinese translation, "组织均匀的纸页" Chinese translation, "组织均匀性" Chinese translation, "组织开发" Chinese translation, "组织抗体粘连试验" Chinese translation, "组织抗氧化系统" Chinese translation
|
|
|
