Mobile
Log In Sign Up
Home > english-chinese > "结晶良好" in Chinese

Chinese translation for "结晶良好"

well-crystallized

Related Translations:
结晶氧化铝:  crystal alumina
结晶习惯:  crystal habit
结晶习性:  crystal habit
结晶冰糖:  crystal candy sugar
结晶剂:  crystallizing agent
结晶橡胶:  crystalline rubber
结晶化学分析:  crystal chemistry analysiscrystalchemistryanalysiscrystallochemical analysis
结晶键:  crystal bridge
结晶熔化:  watery fusion
延迟结晶:  delayed crystallization
Example Sentences:
1.U - series dating of compact and well crystallized cave calcites , with its fairly high reliability , is commonly used for hominid fossil sites
纯净致密、结晶良好的洞穴新生碳酸盐岩铀系年代的可信度已为学术界广泛接受。
2.While u - series dating of compact and well crystallized cave calcites , with its fairly high reliability , is widely used for hominid fossil sites
与此相比,纯净致密、结晶良好的洞穴新生碳酸盐岩的铀系年代已为学术界普遍认可。
3.The layers from substrate to top of the deposited film are ti substrate , buffer layer ( interface between substrate and film ) , porous layer and lamellar layer
研究发现,从钛合金到羟基磷灰石共有四层结构:钛合金基体、钛合金的氧化层、多孔的纳米晶羟基磷灰石和花瓣状的结晶良好的羟基磷灰石。
4.No evident crystallization was present when electron beam flux was below 30ma . the films with best crystallization were obtained when flux was 40 - 50ma . further increasing the flux , the crystallization became worse
蒸发束流在30ma以下时,薄膜未出现明显的结晶,在40 - 50ma时,结晶良好,而在60ma时,结晶性能变差。
5.It showed that better crystal films could formed when sintered between 350 ~ 550 for 3 hours . with the increasing of temperature and the extending of time , the diffraction apices became stronger and the crystal became bigger
薄膜电极的烧结工艺研究结果表明,当烧结温度在350 ~ 550烧结时间为3h时得到结晶良好的limn2o4薄膜,随着温度的升高,衍射峰越来越明显,晶粒越来越大。
6.The sto , ybco and sto / ybco thin films were deposited on laalo3 ( 001 ) ( lao ) substrate by pulsed laser deposition ( pld ) . the effects of deposition parameters , such as the substrate temperature , the of target - substrate distance , laser energy density , on the properties of the thin fillms were systematically studied . the surface morphology of the thin films was investigated by atomic force microscopy ( afm ) and scanning electron microscopy ( sem )
采用脉冲激光沉积技术在laalo3 ( 001 ) ( lao )基片上生长ybco 、 sto以及sto / ybco集成薄膜,系统研究了基片温度、基片表面状态、氧分压、激光能量密度、脉冲重复频率等工艺参数对薄膜表面性能、结晶情况的影响,优化了ybco 、 sto薄膜生长的工艺参数,运用afm 、 sem 、 xrd等分析手段表征薄膜的微观性能,分析结果表明:薄膜表面平整、结晶良好、 c轴织构。
7.The results are as follows : ( 1 ) bst thin film prepared by pulsed laser deposition is well crystallized . the average grain size is 100nm and the surface roughness is about 10nm . when the electric field intensity is 3v / , the tunability of the thin film is about 30 % and the loss tangent is about 20 % under room temperature
研究结果如下: ( 1 )采用脉冲激光沉积法制备的bst薄膜结晶良好,晶粒尺寸在100左右;表面粗糙度约为10 ;室温下,当直流电场为3v /时介电系数变化率约为30 % ,介质损耗约为20 % 。
Similar Words:
"结晶粒度" Chinese translation, "结晶粒合金轧辊" Chinese translation, "结晶粒状结构" Chinese translation, "结晶力" Chinese translation, "结晶连续性" Chinese translation, "结晶良好的" Chinese translation, "结晶裂纹" Chinese translation, "结晶磷光体" Chinese translation, "结晶鳞片石墨" Chinese translation, "结晶领域" Chinese translation