| 1. | The following is an example of the cost in performance of off-design operation .
下面是非设计点工作在性能上损失的一个例子。 |
| 2. | In many practical problems , xi usually are some nonrandom design points , that is , fixed design points
在许多实际问题中，我们遇到的多为x _ i是非随机设计点列，即固定设计点列的情况。 |
| 3. | Their operation is described in the next sections followed by example code to illustrate particular design points
接下来的部分将描述他们是如何运行的，并通过实例代码演示了一些特殊的设计点。 |
| 4. | Finally , use the multiple delay model and multiple design point approach to achieve the control law design for the energy management phase of a reentry vehicle
最后利用多重延迟模型和多重设计点( mdm mdp )方法设计了航天器末端能量管理段的控制律。 |
| 5. | The software fluent was employed and the two - dimensional flow field and performance parameters of four hypersonic / inlet models at design and off - design condition are obtained
采用fluent软件对所设计的进气道设计点和非设计点二维流场和性能进行了数值模拟。 |
| 6. | The results of 3d viscous numerical simulation show that the efficiency of new lpt decreases 2 . 3 percent under the low reynolds number condition , which was compared with that of design point
三维粘性数值模拟的结果显示新低压涡轮效率在高空低雷诺数情况下比设计点下降2 . 3个百分点。 |
| 7. | This paper studies the nonparametric estimates of general weight function of the nonparametric regression function with fixed design points , when the model error is martingale sequence , and we give the optimal convergence rate under some conditions
摘要当误差为鞅差序列时，研究固定设计点列情形下非参数回归函数一般权函数的非参数估计，并在一些基本条件下给出了估计的一致最优强收敛速度。 |
| 8. | By applying the optimal control theory and using the method of multi - designing points to design the cam contour curve with both good dynamic property and strong parametric anti - disturbance force , and the feasibility of this method was verified by a living example
摘要应用最优控制理论，提出以多设计点法来设计既有良好动态特性且抗参数扰动力强的凸轮轮廓曲线，并以实例验证了该方法的可行性。 |
| 9. | The step of this method is : selecting variables and their rang , creating experiment points , establishing parameter models , calculating cfd models , choosing aerodynamic characteristics , establishing surrogate models and setting optimization models
这种方法的步骤是:确定设计变量及其取值范围、生成试验设计点、建立参数化几何模型、应用cfd软件进行数值计算、提取气动特性、构造代理模型和建立优化模型。 |
| 10. | Compared with other design methods of planar transformers , pttdm begins with the temperature rise of planar transformers . for pttdm , the temperature rise is the design standard but riot the ^ verifying standard . therefore , this method can guarantee the planar transformer ' s temperature rise to meet the requirement and shorten the design circle
与其他的设计方法不同，该设计方法是以平面变压器的温度作为设计点，而不是把温度作为校验标准，因此，这种方法可以保证所设计的变压器温度符合预期的要求，并且缩短设计的周期。 |
