| 1. | Temperature of the extrapolated onset
外推起始温度 |
| 2. | Oit oxidative induction temperature
氧化起始温度 |
| 3. | Refer processing conditions section of this web site for recommended starting temperatures
参照本网站的成型条件区作为建议的起始温度。 |
| 4. | This can be caused by the initial oven temperature being set too close to room temperature
这可能是因为柱箱起始温度设定值过于接近室温。 |
| 5. | Refer to processing conditions section of this web site for recommended starting temperatures
参照在网站上建议的成型条件区作为建议的起始温度。 |
| 6. | Results showed that the curing temperature of this system was come down , and the mousiture - resistance of this adhesive was improved
实验结果表明，采用上述的方法，可以大大降低固化的起始温度，并对固化后产物的耐湿热性有一定的提高。 |
| 7. | The results shows that the addition of nucleating agents increased the onset temperature and peak temperature and improved crystallization rate of pp
结果表明，两种成核剂的加入均可提高聚丙烯的结晶起始温度和结晶峰温度，并加快结晶速度。 |
| 8. | The results showed that beginning temperature of sharp lost of weight of wpc was obviously lower than wood , and the temperature of wmc corresponded to wood
结果发现，木材酚醛树脂复合材料的急剧失重起始温度明显比木材低，而木材蒙脱土复合材料的急剧失重起始温度与木材相当。 |
| 9. | It was found that in the case of non - isothermal crystallization , the onset and maximum crystallization temperatures of the nylon 6 of the nanocomposites are increased , while the crystallinity and crystallization growth rate is reduced
在非等温条件下，尼龙6石墨纳米薄片复合体系的结晶起始温度以及最大结晶速率时的温度均比纯尼龙6有明显的提高，但结晶度以及结晶速率却出现下降。 |
| 10. | Tg curves indicate , there were no detectable weight loss below 400 in any composition , the temperature at which weight loss becomes significant decreases , and the magnitude of weight loss increases with increasing sr content , but the onset temperature of weight loss increases and the amou nt of this loss decreases with increasing fe content
热重曲线表明这类材料在400以下未观察到失重现象，随着sr含量的增加，失重的起始温度有所降低，但失重量反而增加；随着fe含量的增加而增加，失重是源于晶格氧的解析，即与氧空位的生成有关。 |
