Chinese translation for "铰支座"
|
- hinged support
Related Translations:
铰轴: cardinal axishinged shaft 半圆铰刀: half round reamerhalf-round reamer 镀锌铁暗铰: galvanized iron concealed hinge
- Example Sentences:
| 1. | Whether the axle pin can be smoothly bolted into the hinge support is crucial for the whole project . to achieve this goal , a prefabricated taper pin was used to induce the axle pin
铰支座穿轴销顺利与否是施工的关键，采用提前做一锥销来引导轴销的方法来实现。 | | 2. | After an introduction to the research on the software for the design of the variant steel arched girder construction , the creation of the structural model , the structure of the supporting seat , the design of the variant arched girder , and the measures taken to ensure the stability of the plane surface of the arched girder , the thesis goes to study the methods for the hoisting and the angle setting of the long - span arched girders , as well as the bolting of the axle pin in the hinge support
论文首先对变异钢拱架结构设计可采用的软件、结构模型的建立、支座构造形式、变异拱梁的设计，以及保证拱梁平面外稳定所采取的措施等进行了研究，然后研究了大跨度变异钢拱架弧形梁吊装、角度的调整、铰支座穿轴销等的施工方法，最后对施工完成后的位移进行了实际量测。 | | 3. | In this study , sts - - the steel construction design module of pkpm , a software program of china " s institute of the construction science - - is employed to create the construction model in order to study the construction of the supporting seat . a mechanical analysis of the variant arched girders was implemented , with the result that consturction documents meeting mechanical requirements were designed for the hinge support , the roller support and the steel girders
本文采用中国建筑科学研究院pkpm软件的钢结构设计模块sts ，从结构建模入手，根据规范要求研究了支座的构造形式，通过对变异拱梁的力学分析，设计出符合力学模型的铰支座、滑移支座和变异拱处钢梁的施工图。 |
- Similar Words：
- "铰支边" Chinese translation, "铰支承" Chinese translation, "铰支梁" Chinese translation, "铰支门形架" Chinese translation, "铰支柱" Chinese translation, "铰制孔" Chinese translation, "铰制螺栓" Chinese translation, "铰轴" Chinese translation, "铰轴安装" Chinese translation, "铰轴长度" Chinese translation
|
|
|
