| 1. | Water level control and alarm devices for industrial boilers
工业锅炉水位控制报警装置 |
| 2. | Marine auxiliary boiler water level gauge
船用辅锅炉水位表 |
| 3. | Simulation of ship boilers ' water level based on the fuzzy intelligent control
组合智能控制理论的船用锅炉水位仿真研究 |
| 4. | This paper uses the boiler water level system as the controlled object , studies and realizes the web - based remote control system
本文以工业锅炉水位控制系统为被控对象，研究并实现了基于web的远程控制系统。 |
| 5. | The test result indicates that the output voltage and water level of the sensor show linear relationship , the sensor can be used for water level detection of boiler
测试结果表明：传感器的输出电压与水位高低变化呈线性关系，可用于锅炉水位的检测。 |
| 6. | Thedeviation was caused by the influence of the condensate temperature in the equalizer andthe positive / negative sampling tubes as well as by the effect of the high ambienttemperature
对此，分析了锅炉水位偏差的原因有平衡容器内凝结水温度问题，正负压取样管内凝结水温差的问题及环境温度高的问题。 |
| 7. | The response was compared with that obtained through simulation realized by the use of matlab and the actual process on different steam flow , feed water flow , fuel flow and control method
并运用matlab仿真工具，针对锅炉水位和汽压调节对象仿真模型在不同的蒸汽负荷、不同给水量、不同燃油量和不同控制方式下的动、静态情况进行仿真研究。 |
| 8. | The neural network - fuzzy control based on clustering analyse is applied to the water level control of boiler in power plant . it can be seen from the simulation that the control quality is high and robustness is strongo
将基于聚类分析的神经网络?模糊控制器应用于火电厂锅炉水位串级控制系统进行仿真研究，实验表明该算法确定的控制系统控制品质较高，鲁棒性强。 |
| 9. | Abstract : this paper introduces the programming essentials and methods for monoboard computer 8098 to realize water level ' s pressure compensation , and analyses the causes of water level ' s deviation in drum boiler occurring in the course of measurement
文摘:本文介绍了单片机8098实现水位压力补偿的编程要点及方法，分析了测量中汽包锅炉水位产生偏差的原因。 |
| 10. | Because there are three inputs accede to adister of water lever control system of boiler , it is easy to bring error of water lever controlling . this iartice puts forward two methods to dispel error of water lever : ( 1 ) assistant signal self - disappear
由于锅炉水位控制系统的调节器输入端常加有三个输入量,极易引起水位控制偏差,本文提出了两种消除水位偏差的方法: ( 1 )辅助信号自消方法( 2 )辅助信号对消方法。 |
