| 1. | The stem has a slightly smaller diameter than the valve bore .
阀杆的直径略小于阀体孔的直径。 |
| 2. | Leave the check assembly parallel to the valve body
使得止回阀总成与阀体平行。 |
| 3. | Carefully press the body into position on the seat
小心地将另一个阀体压进阀座。 |
| 4. | Body & adaptors drawings are rough machined drawings
阀体和接头为粗加工图纸。 |
| 5. | Cast stainless steel body and investment cast yoke
铸造不锈钢阀体和熔模铸造轭架。 |
| 6. | Design of feed system of diecasting die for exhaust valve
排气阀体压铸模浇注系统设计 |
| 7. | Valve assembling ： place the ball into the body
重组阀门：将球放入阀体。 |
| 8. | Outer row of studs secures the yoke to the body
双头螺栓的外部排列将阀架固定在阀体上。 |
| 9. | Note : assembly body should not be painted
注意：总成阀体不应该上漆。 |
| 10. | Tube valves ; swivel type tyre valve , single bend form
内胎气门.有旋转阀体的单弯结构轮胎气门 |
