| 1. | Place the cover o - ring on the diaphragm assembly
将阀盖o形环放置在隔膜总成上。 |
| 2. | Press down on the cover to assure proper alignment
压下阀盖，确保适当的对齐。 |
| 3. | Tighten the cover using the appropriate sized wrench
采用尺寸适当的扳手紧固阀盖。 |
| 4. | Install relief valve cover nut and tighten
安装安全阀阀盖螺母，并加以紧固。 |
| 5. | Install the valve bonnet . torque to 70 ft . / lbs
安装阀盖。扭矩为70英尺/磅。 |
| 6. | Unscrew the bonnet by turning counterclockwise
反时针方向旋转拧松阀盖。 |
| 7. | Technologic analysis of the valve lid and design of the die
阀盖压铸工艺分析及模具设计 |
| 8. | Tightening valve bonnet is necessary to stop any leaks
如果必要紧固阀盖，避免任何泄漏。 |
| 9. | Remove the two hood screws , remove hood
拆卸两个阀盖螺丝，拆卸阀盖。 |
| 10. | Kit includes : seat , retainer wire and cover o - ring
组件包括：阀座，固定器线圈和阀盖o形环。 |
