| 1. | The driver system of a automatic sot diode tape machine
型半导体自动编带封装机编带驱动部分的研制 |
| 2. | The motor driver section uses four n - channel high voltage mosfet
电压驱动部分是利用四组大功率高压mosfet 。 |
| 3. | The data acquisition system and the output driving system are designed emphatically in this paper
本文重点设计了整个平台的数据采集系统和输出驱动部分。 |
| 4. | The run - time loader uses the names of the sections to put parts of your driver in the places you intend
运行时间装载器使用片断的名称来把你的驱动部分放进你想要的位置。 |
| 5. | First , this paper introduces the basic principle , the development , the category of linear motor and its control technology
在电机驱动部分主要说明了电机的控制策略、变频驱动技术的原理和在本系统的实现。 |
| 6. | The constitution of control system of high - speed cnc engraving and milling machine is analyzed in chapter 3 , given emphasis to motion controller , spindle driver and feed driver
第三章分析了计算机高速数控雕铣伺服系统的构成，着重研究了运动控制器、主轴驱动部分和进给驱动部分。 |
| 7. | In the servo driving system of the robot , expensive servo motors are replaced by common direct motors and magnetic encoder . finally , the closed loop control of motors are successful realized
在机器人底层平台的伺服驱动部分，用普通的直流电机加上磁性编码器(码盘)取代昂贵的伺服电机系统，成功实现电机的闭环控制。 |
| 8. | The hardware is a single chip microcomputer system . the cpu of the microcomputer is intel 196kc . the hardware consists of switch signal par , analog signal collecting part , microcomputer and driving part
硬件部分以intel196kc单片机为核心，主要由开关量输入输出部分、模拟信号采集部分、单片机部分和驱动部分组成。 |
| 9. | Abstract : the three - phase circuit is regarded as some of drive of the whole power system in actual project , it has its special meaning in practical application carry on correct use and particularly important control to it
摘要：三相电路作为实际工程中整个电力系统的驱动部分，在实际应用中有其特殊的意义，因此对其进行正确的利用和控制尤为重要。 |
| 10. | 1 driving part : this machine adopts triangle beltdouble - grade drive for shaft speed reducer , speed reducer is installed on shaft head of driving roller ; all driving devices are installed on the machine frame viahead sheave rack and motor rack
1驱动部分：该机采用三角皮带轴装式减速器两级传动，减速器套装在传动滚筒的轴头上全部传动装置通过头轮架和电机架悬挂安装在机架上。 |
