Chinese translation for "刮膜"

knifing

Related Translations:

刮入:  whibber

刮除法:  curettagesgraffito

新雨刮:  piaa

用刮匙刮:  curette

刮了:  xoha

刮心平刮板:  core strickle

刮斗机:  bullclam

刮净器:  cleanser

刮泥器:  sludge scraper

刮声器:  scraper

Example Sentences:

	1.	Numerical simulation on wiped film distillation of dbp - dbs 刮膜分子蒸馏过程数值模拟
	2.	Mathematic model of mass transfer and heat transfer of wiped film molecular distillation 刮膜分子蒸馏传质和传热的数学模型
	3.	When coagulant bath temperature was at 15 c , the flat membrane was smooth , and the defects disappeared 温度为15时，所刮膜平整光滑，缺陷消失。
	4.	For flat films , the cellulose chains are almost unoriented within the plane parallel to the film surface 另外，刮膜速度、拉伸比和吹胀比对膜强度和超分子结构的影响也很大。
	5.	The strength of flat film made by casting method is only 55mpa , while that of tubular film made by blown - extrusion method is high to 250mpa and is 2 . 5 times strength of cellophane 刮膜法制备的平膜强度较低，而吹膜法制备的管膜强度达250mpa ，是玻璃纸的2 . 5倍，这与分子链的取向有关。
	6.	The optimized process parameters are : the concentration of casting solution is higher than 9wt % , casting speed is 0 73m / min , temperature of wash bath is 45 and post - treatment is used 当铸膜液浓度在9wt以上，刮膜速度为0 . 73m min ，水洗浴温度为45 ，并增加热处理和塑化处理时，膜的分离性能较好。
	7.	With an increase of nmmo concentration of coagulation bath or concentration of casting solution , the crystallinity of membrane increases . however , an increase of temperature of coagulation bath is accompanied by a decrease of crystallinity of membrane 膜的结晶度随铸膜液浓度、凝固浴浓度、刮膜速度的增加而增大，随凝固浴温度的升高而降低。

Similar Words：

"刮面热交换器" Chinese translation, "刮面石" Chinese translation, "刮面式换热器" Chinese translation, "刮面式套管结晶机" Chinese translation, "刮模面" Chinese translation, "刮膜式蒸发器" Chinese translation, "刮磨" Chinese translation, "刮抹" Chinese translation, "刮墨刀" Chinese translation, "刮墨刀角度" Chinese translation